A dryer that smells like something is burning gets your attention fast, and it should. Sometimes the cause is harmless: a brand-new heating element or paint fumes from a weekend project. Sometimes it is a vent packed with lint or a part running too hot. And on a gas dryer, a gas smell is its own category with its own rule. This guide covers what the manufacturers’ manuals say about dryer odors, what you can safely check, and what belongs to a technician.
First: if you smell gas, this is not a repair question
If your dryer runs on natural gas or propane and you smell gas, act before anything else. The Kenmore (Whirlpool-built) Use and Care Guide lists what to do:
- Do not try to light any appliance.
- Do not touch any electrical switch, and do not use any phone in your building.
- Clear the room, building or area of all occupants.
- Immediately call your gas supplier from a neighbor’s phone and follow the supplier’s instructions.
- If you cannot reach your gas supplier, call the fire department.
The same guide warns that gas leaks cannot always be detected by smell, that gas suppliers recommend a gas detector approved by UL or CSA, and that installation and service on a gas dryer must be done by a qualified installer, service agency or the gas supplier. The LG laundry center service manual in our library carries the same “what to do if you smell gas” statement. Call us only after the gas supplier has cleared the home.
Smells the manuals call normal
| Situation | What the manual says |
|---|---|
| Electric dryer used for the first time | The new electric heating element may have an odor, gone after the first cycle |
| Recent painting, staining or varnishing nearby | Ventilate the area; when the fumes are gone, rewash and dry the clothing |
If the smell fades after a load or two in a new dryer, that matches the manual. If it keeps coming back, or an older dryer never had an odor before, the first-use explanation does not apply.
Fumes from the laundry itself are a separate matter. The Kenmore guide says not to dry articles that have been cleaned in, washed in, soaked in or spotted with gasoline, dry-cleaning solvents or other flammable or explosive substances, because they give off vapors that could ignite or explode. It also says items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire. If the smell started with a particular load, stop the dryer and take that load out.
A hot or burning smell while the dryer runs
Scorched fabric, hot dust, hot plastic or an electrical odor is not covered by the new-dryer explanation. The manuals do not list one cause, but they point in one direction: heat that cannot leave the dryer.
The Kenmore guide says not to run the dryer with the lint screen loose, damaged, blocked or missing, because doing so can cause overheating and damage to both the dryer and the fabrics. It also says to keep the area around the exhaust opening free from the accumulation of lint, dust and dirt.
The Frigidaire laundry center service manual explains what protects the dryer when heat builds up. A high-limit thermostat is a secondary safety feature that keeps the dryer from getting very hot: if the temperature rises past its limit, it opens the circuit that powers the heater. The manual says blocked or clogged vents are one of the most common causes of that thermostat tripping. It also lists a diagnostic code, E65, for a high-limit thermostat that has tripped too many times, with causes of excessive exhaust blockage, a defective thermostat or a wiring failure. That is one brand and model family; other dryers show different codes or none, and our technician reads the actual fault on site.
What you can safely check yourself
These are owner actions the manuals themselves describe. None involves opening the dryer.
- Stop the dryer and let it cool. If the smell is strong or you see smoke, do not keep running cycles to see if it goes away.
- Clean the lint screen. Kenmore says to clean it before or after every load by pulling it out and rolling the lint off with your fingers. If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.
- Look at the outside vent hood. Frigidaire describes a vent hood with a swing-out damper that opens when the dryer runs and closes when it stops. Kenmore suggests running the dryer 5 to 10 minutes and holding your hand under the outside hood to check air movement. No air means the exhaust is probably restricted. The LG manual adds that a screen should not be fitted on the end of the duct, because lint covers it and blocks the vent.
- Check what went in. Kenmore says not to use heat to dry articles containing foam rubber or rubber-like materials.
If the smell persists once the screen and hood are clean, stop using the dryer and book a visit. Cleaning inside the cabinet and the whole vent run is professional work. Kenmore says lint should be removed from the cabinet and the exhaust vent every 2 years or more often, with cabinet cleaning done by a qualified servicer. Frigidaire says to inspect and clean the exhaust system at least every 18 months with normal use, and LG recommends cleaning the vent at least once a year. The schedules differ, so the safe reading is more often if you dry a lot, and sooner if you smell something.
What the installation documents require for the vent
| Item | What the manual says |
|---|---|
| Duct material | No flexible plastic or metal foil venting; it collapses, is easily crushed and traps lint (Kenmore, Frigidaire) |
| Duct size | 4 inch (102 mm) diameter heavy, rigid vent (Kenmore); 4 inch rigid or flexible metal duct with an approved hood (Frigidaire) |
| Bends | No more than four 90 degree elbows; each bend reduces airflow (Kenmore) |
| Semi-rigid duct | Do not exceed 8 ft. (2.4 m) (Frigidaire) |
| Termination | Outdoors only, never into a wall, ceiling, attic or crawl space (Frigidaire) |
Both manuals label bad venting a fire hazard, and Kenmore adds that service calls caused by improper venting are not covered by the warranty. When the problem is the vent rather than the dryer, the LG manual tells the technician to refer the customer to a professional ductwork company, and we will say so honestly.
What usually needs a booked repair
| Likely cause | What we check, and when to call |
|---|---|
| Restricted exhaust or crushed duct | Airflow at the hood and through the run. Call if the hood is clear but drying is slow or hot |
| Tripped or failed thermostats, thermal fuse | The devices that cut heat on overheating. Call if heat stopped after a burning smell |
| Heating element or gas burner | Element or burner condition. Call for any smell that returns after the first-use period |
| Worn belt or rollers | Rubber or friction smell with squealing or thumping. Call before the belt breaks |
| Motor running hot | Hot-motor smell with a slow or stalling drum. Call right away and stop using the dryer |
The LG manual describes the protection chain for an electric model: a thermal cut-off, a high-limit thermostat and an outlet thermostat each open the circuit at set temperatures. Its first step for the technician is the lint filter, and it tells the technician to explain to the owner that keeping the filter clean is their responsibility for performance and safety. A visit that ends with a clogged vent is still a good outcome: the part was fine.
When to stop using the dryer
- You smell gas: leave the home and call the gas supplier first.
- A hot or electrical smell continues after you clean the lint screen.
- You see smoke or scorching, or the cabinet is very hot.
- The drum squeals, stalls or runs slowly along with the smell.
Do not remove panels or try to test parts yourself.
A Colorado detail worth knowing
Many Denver Metro homes put the dryer in a garage, basement or closet. Both the Kenmore guide and the Frigidaire manual say a dryer installed in a garage must sit at least 18 inches above the floor, with gasoline and other flammables kept away from it. Kenmore also says proper cycles need a room above 45°F (7°C), which matters in an unheated garage in winter, and that a closet door needs ventilation openings at the top and bottom.
Dryer repair across the Denver Metro
A burning smell has several possible causes, and our technicians sort them out on site. Related guides: dryer takes too long to dry, dryer not heating and dryer stops mid-cycle, all common companions of a restricted vent. We diagnose first, quote the repair and credit the diagnostic fee toward it if you go ahead, using genuine OEM parts.
FiXiFY serves Denver, Aurora, Lakewood and Westminster and the surrounding Metro area. See dryer repair for how a visit works, or browse the repair guides hub.
BOOK ONLINECALL (303) 214-1240
FAQ
Is it normal for a new dryer to smell?
The Kenmore guide says a new electric heating element may have an odor, and that the odor will be gone after the first cycle. If the smell continues beyond the first loads, have it checked.
What should I do if my gas dryer smells like gas?
Do not light anything, do not touch electrical switches or use a phone inside, and get everyone out. Call your gas supplier from a neighbor’s phone, or the fire department if you cannot reach them.
Can a clogged vent make a dryer smell like it is burning?
A blocked vent traps heat. The Frigidaire service manual calls blocked vents one of the most common reasons the high-limit thermostat trips, so a vent check is the first thing to rule out.
How often should the dryer vent be cleaned?
The manuals differ: Kenmore says every 2 years or more often, Frigidaire at least every 18 months, and LG at least once a year. Clean it sooner if you dry heavy loads or notice a smell.
FiXiFY Appliance Repair — 7030 E 46th Ave Dr, Unit A, Denver, CO 80216 · (303) 214-1240 · support@fixifycolorado.com
